A comparative study between chloride and calcined carbonate hydrotalcites as adsorbents for Cr(VI)

Hydrotalcite-type solids with different metal ions within the layers (M^II = Mg or Zn and M^III = Al and/or Fe) and carbonate or chloride between them have been synthesized. Chloride-LDHs and the solids obtained upon carbonate-LDHs calcination have been evaluated in the adsorptive removal of Cr(VI) from aqueous solutions. All the adsorption tests were carried out at 30 °C following two different stirring conditions: a) using a thermostatic bath with mechanical stirring at a speed of 52 rpm or b) in a sonicator bath under ultrasound waves. It was observed that no significant difference in the amount of adsorbed chromate is produced in both cases but the time spent to reach the equilibrium is much lower when the adsorbent/adsorbate mixture is submitted to ultrasounds. In all experiments L-type adsorption isotherms were obtained. The results show that chloride hydrotalcites are better adsorbents than calcined CO₃-hydrotalcites and in these last ones their adsorption capacity increases with increasing the surface area: MgAlFe > MgAl > MgFe > ZnAl.     

Isomerization of n-hexane over mono- and bimetallic Pd–Pt catalysts supported on ZrO2–Al2O3–WOx prepared by sol–gel

The catalytic performance of mono- and bimetallic Pd (0.6, 1.0 wt.%)–Pt (0.3 wt.%) catalysts supported on ZrO₂ (70, 85 wt.%)–Al₂O₃ (15, 0 wt.%)–WO_x (15 wt.%) prepared by sol–gel was studied in the hydroisomerization of n-hexane. The catalysts were characterized by N₂ physisorption, XRD, TPR, XPS, Raman, NMR, and FT-IR of adsorbed pyridine. The preparation of ZrW and ZrAlW mixed oxides by sol–gel favored the high dispersion of WO_x and the stabilization of zirconia in the tetragonal phase. The Al incorporation avoided the formation of monoclinic-WO₃ bulk phase. The catalysts increased their S_BET for about 15% promoted by Al₂O₃ addition. Various oxidation states of WO_x species coexist on the surface of the catalysts after calcination. The structure of the highly dispersed surface WO_x species is constituted mainly of isolated monotungstate and two-dimensional mono-oxotungstate species in tetrahedral coordination. The activity of Pd/ZrW catalysts in the hydroisomerization of n-hexane is promoted both with the addition of Al to the ZrW mixed oxide and the addition of Pt to Pd/ZrAlW catalysts. The improvement in the activity of Pd/ZrAlW catalysts is ascribed to a moderated acid strength and acidity, which can be correlated to the coexistence of W⁶⁺ and reduced-state WO_x species (either W⁴⁺ or W⁰). The addition of Pt to the Pd/ZrAlW catalyst does not modify significantly its acidic character. Selectivity results showed that the catalyst produced 2MP, 3MP and the high octane 2,3-dimethylbutane (2,3-DMB) and 2,2-dimethylbutane (2,2-DMB) isomers.     

Enhancing decentralized service discovery in open service-oriented multi-agent systems

Service-oriented multi-agent systems are dynamic systems that are populated by heterogeneous agents. These agents model their functionality as services in order to allow heterogeneous agents or other entities to interact with each other in a standardized way. Furthermore, due to the large-scale and adaptative needs of the system, traditional directory facilitators or middle-agents are not suitable for the management of agent services. This article proposes the introduction of homophily in service-oriented multi-agent systems to create efficient decentralized and self-organized structures where agents have a greater probability of establishing links with similar agents than with dissimilar ones. This similarity is based on two social dimensions: the set of services that an agent provides and the organizational roles that it plays. A second contribution is an algorithm for service discovery that it is carried out taking into account the local information that is related to the homophily between agents. The experiments compare our proposal with other proposals in distributed environments. The results show that the proposed structure and algorithm offer desirable features for service discovery in decentralized environments. Specifically, these features provide short paths and a high success rate in the service discovery process and resilience under deliberate failures.     

Synthesis,characterization, and metal complexation of poly(N‐phenylmaleimide‐co‐acrylic acid) and poly(N‐phenylmaleimide‐co‐acrylamide) as polychelatogens in aqueous solution

We carried out the free‐radical copolymerization of N‐phenylmaleimide with acrylic acid and acrylamide with an equimolar feed monomer ratio. We carried out the synthesis of the copolymers in dioxane at 70°C with benzoyl peroxide as the initiator and a total monomer concentration of 2.5M. The copolymer compositions were obtained by elemental analysis and ¹H‐NMR spectroscopy. The hydrophilic polymers were characterized by elemental analysis, Fourier transform infrared spectroscopy, ¹H‐NMR spectroscopy, and thermal analysis. Additionally, viscosimetric measurements of the copolymers were performed. Hydrophilic poly(N‐phenylmaleimide‐co‐acrylic acid) and poly(N‐phenylmaleimide‐co‐acrylamide) were used for the separation of a series of metal ions in the aqueous phase with the liquid‐phase polymer‐based retention method in the heterogeneous phase. The method is based on the retention of inorganic ions by the polymer in conjunction with membrane filtration and subsequent separation of low‐molecular‐mass species from the formed polymer/metal‐ion complex. The polymer could bind several metal ions, such as Cr(III), Co (II), Zn(II), Ni(II), Cu(II), Cd(II), and Fe(III) inorganic ions, in aqueous solution at pH values of 3, 5, and 7. The interaction of the inorganic ions with the hydrophilic polymer was determined as a function of pH and a filtration factor. Hydrophilic polymeric reagents with strong metal‐complexing properties were synthesized and used to separate those complexed from noncomplexed ions in the heterogeneous phase. The polymers exhibited a high retention capability at pH values of 5 and 7. © 2005 Wiley Periodicals, Inc. J Appl Polym Sci, 2006     

Evaluation of the antimicrobial action of honey against Staphylococcus aureus, Staphylococcus epidermidis, Pseudomonas aeruginosa, Escherichia coli, Salmonella enteritidis, Listeria monocytogenes and Aspergillus niger. Evaluation of its microbiological charge

The evaluation of the microbiological charge present in Costa Rican samples as the evaluation of its antimicrobial activity over different microorganisms, including those associated to wound infections, will allow to emit criteria referred to its use in therapeutic treatments, specially as alternative therapy for cases involving antibiotic resistant bacteria. The microbiological charge of 25 honey samples, acquired in Costa Rican markets was evaluated through several indicators including total plate aerobic count, total plate anaerobic count, total aerobic spore count, total anaerobic spore count and molds and yeast count. Also, samples were inoculated in tubes with chopped meat media and plated in egg yolk agar in order to determine the presence of Clostridium botulinum. For the antimicrobial activity evaluation, the diffusion method in Muller Hinton agar was performed, testing different honey concentrations (100, 75, 50, 25, 12,5 and 6,25 % v/v) against Staphylococcus aureus (ATCC 25923), Staphylococcus epidermidis (UCR 2902), Pseudomonas aeruginosa (ATCC 9027), Escherichia coli (ATCC25922), Salmonella enteritidis (ATCC 13076), Listeria monocytogenes (ATCC 19116) and Aspergillus niger. The results obtained for the microbiological characterization of honey show that 91% of samples had counts equal or lower than 1,0 x 10(1) CFU/g. No positive result was obtained for the isolation of C. botulinum. 24 of the samples analyzed inhibited the growth of S. aureus even in a 25% v/v concentration, nevertheless, A. niger was no inhibited by any of the samples tested.     

Crack–Tip Toughness of a Soft Lead Zirconate Titanate

Crack–opening displacement (COD) measurements were performed on a commercial lead zirconate titanate (PZT). The intrinsic fracture toughness (or crack–tip toughness) of this material was determined using a new evaluation procedure, which takes into account the near–tip CODs and complete crack profile CODs. The crack–tip toughness K _I0 was determined from an extrapolation of COD data obtained at various loading stages, thus avoiding the complications caused by subcritical crack growth in PZT. Results for plane strain and plane stress condition are presented.     

Fracture mechanics model for subthreshold indentation flaws

A fracture mechanics model for subthreshold indentation flaws is. described. The model describes the initiation and extension of a microcrack from a discrete deformation-induced shear fault (shear crack) within the contact zone. A stress-intensity factor analysis for the microcrack extension in residual-contact and applied-stress fields is used in conjunction with appropriate fracture conditions, equilibrium in Part I and non-equilibrium in Part II, to determine critical instability configurations.In Part I, the K-field relations are used in conjunction with the Griffith requirements for crack equilibrium in essentially inert environments to determine: (i) the critical indentation size (or load) for spontaneous radial crack pop-in from a critical shear fault under the action of residual stresses alone; (ii) the inert strengths of surfaces with subthreshold or postthreshold flaws. The theory is fitted to literature data for silicate glasses. These fits are used to calibrate dimensionless parameters in the fracture mechanics expressions, for later use in Part II. The universality of the analysis in its facility to predict the main features of crack initiation and propagation in residual and applied fields will be demonstrated. Special emphasis is placed on the capacity to account for the significant increase in strength (and associated scatter) observed on passing from the postthreshold to the subthreshold domain.     

Influence of different reactor types on Nannochloropsis oculata microalgae culture for lipids and fatty acid production

Greenhouse gases emitted into the atmosphere by burning of fossil fuels cause global warming. One option is obtaining biodiesel. Nannochloropsis oculata was cultured under different light intensities and reactors at 25°C for 21 days with f/2 medium to assess their effects on cell density, lipid, and fatty acids (FAs). N. oculata improved cell density on fed-batch glass tubular reactor (7 L) at 200 μmol E m⁻² s⁻¹, yielding 3.5 × 10⁸ cells ml⁻¹, followed by fed-batch Erlenmeyer flask (1 L) at 650 μmol E m⁻² s⁻¹ with 1.7 × 10⁸ cells ml⁻¹. The highest total lipid contents (% g lipid × g dry biomass⁻¹) were 44.4 ± 0.8% for the reactor (1 L) at 650 μmol E m⁻² s⁻¹ and 35.2 ± 0.2% for the tubular reactor (7 L) at 200 μmol E m⁻² s⁻¹, until twice as high compared with the control culture (Erlenmeyer flask 1 L, 80 μmol E m⁻² s⁻¹) with 21.2 ± 1%. Comparing the total lipid content at 200 μmol E m⁻² s⁻¹, tubular reactor (7 L) and reactor 1 L achieved 35.2 ± 0.2% and 28.3 ± 1%, respectively, indicating the effect of shape reactor. The FAs were affected by high light intensity, decreasing SFAs to 2.5%, and increased monounsaturated fatty acids + polyunsaturated fatty acids to 2.5%. PUFAs (20:5n-3) and (20:4n-3) were affected by reactor shape, decreasing by half in the tubular reactor. In the best culture, fed-batch tubular reactor (7 L) at 200 μmol E m⁻² s⁻¹ contains major FAs (16:0; 38.06 ± 0.16%), (16:1n-7; 30.74 ± 0.58%), and (18:1n-9; 17.15 ± 0.91%).     

Stream fusion for multi-stream automatic speech recognition

Multi-stream automatic speech recognition (MS-ASR) has been confirmed to boost the recognition performance in noisy conditions. In this system, the generation and the fusion of the streams are the essential parts and need to be designed in such a way to reduce the effect of noise on the final decision. This paper shows how to improve the performance of the MS-ASR by targeting two questions; (1) How many streams are to be combined, and (2) how to combine them. First, we propose a novel approach based on stream reliability to select the number of streams to be fused. Second, a fusion method based on Parallel Hidden Markov Models is introduced. Applying the method on two datasets (TIMIT and RATS) with different noises, we show an improvement of MS-ASR.     

Is It Possible to Retain Customer Loyalty When a Service Has Failed?

This article aims to analyze the impact of recovery on loyalty in the context of a service chain characterized by the e‐quality–perceived value–loyalty relationship. A sample of 91 out of 1,201 respondents claimed to have had service problems with an online travel agency website. A causal model to test relationships was performed using structural equations modeling, and it was found that data fit with the proposed model. The really important point to retaining customers is quality. It is not so clear that the recovery effort might affect loyalty. Our findings underpin some previous stream of literature confirming that recovery does not always affect loyalty. Although the literature has not reached a consensus in this topic, we add new elements in this debate.